Third Day, Week 4

Assalamualaikum w.b.t...

Third Day, Week 4 

WEDNESDAY,18 July 2012    


     I'm still working to complete the circuit schematic given by Mr. mazran. When we have done finishing the design circuit, the circuit will be convert to PCB layout. On PCB layout, we must make sure that the list of components to be used in the circuit.

    In PCB layout, the problems usually happen is to arrange the pist of components. We can see that, 

1. Yellow Line = refer to proposed location of component.
2. Green Line  = refer to electrical connection for our component. 

In component mode, make sure list of components to be placed is empty. Then, set board edge, and take 2D graphic box mode at vertical toolbar and change it to board edge mode. After routing, the green line show there is no connection between to point. Blue line show bottom copper (button connection). Use jumper to connect any placer that can't connect using proteus..

solar switch in schematic design

solar switch in PCB lsyout